![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
If I could spend some time figuring out if IFIT in it with a chute.. I'd be interested.
I've flown one.. but without a chute, and with the seat back removed. I went and looked at one in Saratoga, but could not fit with the chute. Well, I fit, but it took 4 tries. Any chance you have the higher leg cutouts on the panel? JP |
#2
|
|||
|
|||
![]() |
#3
|
|||
|
|||
![]()
On Wednesday, June 22, 2016 at 7:08:52 PM UTC-4, wrote:
If I could spend some time figuring out if IFIT in it with a chute.. I'd be interested. I've flown one.. but without a chute, and with the seat back removed. I went and looked at one in Saratoga, but could not fit with the chute. Well, I fit, but it took 4 tries. Any chance you have the higher leg cutouts on the panel? JP JP: Buy a glider you fit in. This glider is an early one with the "small" cockpit. Depending on build, suitable for guys up to about 6'. -Evan Ludeman |
#4
|
|||
|
|||
![]()
Thanks
I'm 6'1" so not too freakish.. however it must be a bunch in my torso. I just felt like i had to lean my forehead way back, or way forward to fit in the 24. I think Williams had a small cushion that was made for when the seat back was out. I'll keep 'fit testing' them thanks JP |
#5
|
|||
|
|||
![]()
If you are looking for a spacious glider in the LD-area of a 24 you could also consider a SZD 55.
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
FAA proposes AD on Schempp-Hirth Discus 2 and Ventus 2 | Mark628CA | Soaring | 8 | May 8th 16 11:33 PM |
Ventus B, Discus ect aileron connecting rod/slide lube | [email protected] | Soaring | 22 | February 4th 15 05:52 PM |
New Ventus 2 and Discus Winglets - M&H | Alpha Eight | Soaring | 11 | February 21st 12 04:41 PM |
Ventus/Discus proposed AD for elevator? | Stewart Kissel | Soaring | 7 | March 9th 04 08:48 PM |
Discus 2, Ventus 2 Technical Note/AD | Chris OCallaghan | Soaring | 2 | October 30th 03 10:19 PM |