|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
March 17th 17, 06:27 AM
posted to rec.aviation.soaring
|
|||
|
|||
Discus B aileron sealing
I am rather certain that it was standard to seal top and bottom.
I have run a teflon tape over the top gap and then mylar over the top mainly because there was a recess for it in the wing. Any gap that you can drive a horse and cart through should be sealed 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aileron inboard edge sealing | Piotr Jaszczuk | Soaring | 14 | March 10th 16 11:41 PM |
| Ventus B, Discus ect aileron connecting rod/slide lube | [email protected] | Soaring | 22 | February 4th 15 05:52 PM |
| Discus Aileron Seals | Peter F[_2_] | Soaring | 8 | August 20th 13 05:07 PM |
| left aileron for Discus CS wanted | [email protected] | Soaring | 0 | September 28th 12 01:31 AM |
| [LBA] Schempp-Hirth - Discus bT - Discus | Frederic FUCHS | Soaring | 0 | September 17th 03 08:42 AM |
Hybrid Mode
