|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 15th 13, 11:38 PM
posted to rec.aviation.soaring
|
|||
|
|||
FLARMCFG entry to turn on PowerFLARM brick serial port
I've seen both of these in example FLARMCFG files, are they both correct?
# configure D-SUB 9 port $PFLAC,S,NMEAOUT2,61 $PFLAC,S,BAUD2,2 and # For brick, turn on output data on DB9 serial port (both GPS and FLARM). # Needed if you want this data ! # Ignored on portable. $pflac,s,nmeaout2,1 Kirk 66 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LX Zeus and PowerFLARM Brick | Gabriel Duford | Soaring | 4 | October 4th 12 10:48 PM |
| Powerflarm Brick feedback | Ramy | Soaring | 7 | August 10th 12 02:02 AM |
| PowerFLARM Brick and PowerFLARM Remote Display Manuals Available | Paul Remde | Soaring | 30 | May 26th 12 12:58 AM |
| PowerFLARM 'brick' progress? | Frank Paynter[_2_] | Soaring | 5 | November 13th 11 08:28 PM |
| Display for PowerFLARM brick | Andy[_1_] | Soaring | 4 | May 10th 11 03:32 PM |
Threaded Mode