|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#13
August 24th 04, 03:10 PM
|
|||
|
|||
"Julian Scarfe" wrote in message
... So when you lower the flap handle in a manual Piper system, does it drag the flaps up or does it merely take the latch away and allow the spring to do its job, as in the electrical equivalent? Hardly a definitive answer but I seem to remember pre-flighting something (may have been a PA28) where the flaps stuck down when I put the lever back down. A quick nudge freed them. Paul 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Flap Hinge Moment Calc | Bo | Home Built | 2 | February 2nd 05 11:26 AM |
| Flap Hinge Moment Calc | Bo | Home Built | 0 | February 2nd 05 07:01 AM |
| Flap angles | DeltaDeltaDelta | Piloting | 34 | May 18th 04 01:09 AM |
| McFarlane flap rollers - PIREP please | Roger Long | Owning | 3 | November 3rd 03 11:04 PM |
| Flap design question | Chris W | Home Built | 1 | August 4th 03 03:50 PM |
Threaded Mode