|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#20
December 27th 04, 08:59 PM
|
|||
|
|||
Fitzair4 wrote: Bates Engineering has a DOS computer program for designing a wing spar. www.aeroOptimizer.com I have met him and listen to his forums at Oshkosh many times. Larry Fitzgerald About the Bates Engineering DOS programs....I have never used DOS and didn't start "computin" until Windows became the "standard?" Are the programs such that they can have the required info input into standard Excel worksheets? If they can, the spar program would be a great tool to play with in designing an I-beam spar similar to what the Vans aircraft use. Neal 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cvjetkovic ca-65 skyfly- plywood spar? | patrick mitchel | Home Built | 3 | October 16th 04 06:26 PM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 2 | February 3rd 04 12:41 AM |
| Marske spar workshop | Marske Flying Wings | Home Built | 0 | October 14th 03 05:53 PM |
| Carbon Spar design and construction workshop | Marske Flying Wings | Home Built | 0 | September 18th 03 06:47 PM |
| Worthy EAA Construction Books | Brock | Home Built | 5 | September 16th 03 08:48 PM |
Threaded Mode