|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#13
July 11th 05, 05:55 PM
|
|||
|
|||
I prefer not to anodize anything on the airplane. Anodizing forms a VERY
hard insulating film that you have to spot-face down to the aluminum to make an electrical connection. I prefer to powder coat, which is nearly as tough under operating conditions but not nearly as difficult to get an electrical connection. Jim The best way is to get the whole panel laser cut and then anodized black after test fitting the instruments. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Are All Batteries Created Equal? (Does Size Matter?) | [email protected] | Soaring | 4 | July 17th 05 03:04 PM |
| DIGGING A DEEPER HOLE | Cribsheet | Piloting | 3 | December 10th 04 01:00 AM |
| Oil Temperature sending unit | Corky Scott | Home Built | 2 | October 19th 04 01:58 AM |
| Finding vent hole in wing skin | Martin Eiler | Soaring | 7 | November 21st 03 02:44 PM |
| Fairing question... | Tina Marie | Home Built | 5 | July 16th 03 01:18 AM |
Threaded Mode