|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#16
January 20th 06, 12:09 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Master Buss Bar?
"ELIPPSE" wrote For instance, 1/8" X 1" 6063-T5 aluminum, such as in the Macklinburg-Duncan display at your hardware store, has the same conductivity as AWG 0-1 OFHC copper but at half the weight and much less cost. That's how I made my two 8' battery conductors in my Lancair that go from the battery in the baggage compartment to the engine. What did you use for insulation, on the positive bar? -- Jim in NC 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Source for PA28-180 split master switch | Mike Noel | Owning | 3 | October 5th 05 03:29 AM |
| Master Jet Base | MICHAEL OLEARY | Naval Aviation | 24 | April 22nd 05 08:00 AM |
| Premade master and circuit breaker panel | Corky Scott | Home Built | 6 | March 19th 04 03:18 PM |
| ANG Woman Wing Commander Doesn't See Herself as Pioneer, By Master Sgt. Bob Haskell | Otis Willie | Military Aviation | 0 | March 18th 04 09:40 PM |
| Need G-103 Acro Master Cylinder | Ray Lovinggood | Soaring | 5 | September 30th 03 04:39 AM |
Threaded Mode