|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
November 6th 06, 07:50 PM
posted to rec.aviation.owning
|
|||
|
|||
Removing oil galley plug
On Nov 6, 12:33 pm, "Jim Burns" wrote: I've considered the hand impact driver as I actually own one, but I'm tentative due to the aluminum case. Any positive/negative experiences? The impact driver isn't going to hurt the case but the lack of control from a swinging hammer just might cause you to strip out the hex in a situation where a wrench handle in knowledgeable hands, wouldn't. What is the hex key size? 3/16 inch? NRP 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fouled plug IO 470 | [email protected] | General Aviation | 7 | January 29th 06 07:03 PM |
| Plug fouled | Denny | Owning | 9 | September 2nd 05 06:58 AM |
| Plug replacements for O-360-A3A | [email protected] | Owning | 3 | August 20th 05 11:39 PM |
| ICOM Headset Adaptor Plug | Ron Wanttaja | Home Built | 3 | June 2nd 05 08:54 AM |
| Helicopter headset plug - help needed | NewsGroups | Home Built | 4 | September 8th 04 06:21 PM |
Threaded Mode