|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
March 27th 14, 01:09 AM
posted to rec.aviation.soaring
|
|||
|
|||
Looking for a trailer wheel
I just did a bit of web searching, and I now believe that "ET27" refers to an offset of 27mm or 1-1/16". Given the width of 4.5", I think that for most steel wheels that would correspond to a backspacing of 3.81".
If that is so, now all you need is the bolt circle. The best bet is to measure it as I wrote earlier. Although, if it is a European glider trailer, I would put my money on 4-on-108mm. Thanks again, Bob K. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Jockey wheel for PIK-20 trailer | lynn | Soaring | 1 | November 23rd 12 07:16 AM |
| Komet trailer wheel bearings | Dan[_6_] | Soaring | 7 | February 9th 09 06:13 AM |
| truck + 5th wheel RV + glider trailer ?? | Steve Koerner | Soaring | 16 | March 27th 07 03:44 AM |
| Avionic trailer wheel needed | qflyer1 | Soaring | 6 | December 7th 06 03:30 PM |
| Q about trailer wheel bearings | Ken Ward | Soaring | 1 | September 15th 06 02:40 AM |
Threaded Mode