A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Piloting
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

High wings and structural strength



 
 
Thread Tools Display Modes
  #1  
Old November 23rd 06, 04:34 PM posted to rec.aviation.piloting
Newps
external usenet poster
 
Posts: 1,886
Default High wings and structural strength



Kev wrote:



Hmm. So about $100 per pound lost, which isn't too bad. Especially
compared to speed mods like gap seals etc, which cost what? $1000 per
mph gained? Something like that? It's been a while since I
researched that.


Gap seals are dirt cheap. I can get gap seals for my ailerons that are
really just tape. Around $100 for the kit. Several companies sell gap
seals for the flaps of Cessna's. Maybe $300 for a typical 182.
  #2  
Old November 23rd 06, 05:07 PM posted to rec.aviation.piloting
karl gruber[_1_]
external usenet poster
 
Posts: 396
Default High wings and structural strength

News,

Where do you get the "just tape" aileron gap seals?

Karl



"Newps" wrote in message
. ..


Kev wrote:



Hmm. So about $100 per pound lost, which isn't too bad. Especially
compared to speed mods like gap seals etc, which cost what? $1000 per
mph gained? Something like that? It's been a while since I
researched that.


Gap seals are dirt cheap. I can get gap seals for my ailerons that are
really just tape. Around $100 for the kit. Several companies sell gap
seals for the flaps of Cessna's. Maybe $300 for a typical 182.



  #3  
Old November 23rd 06, 05:57 PM posted to rec.aviation.piloting
Newps
external usenet poster
 
Posts: 1,886
Default High wings and structural strength

Not being a Cessna guy anymore I don't recall which companies sold the
tape kits. Here's a few links for gap seals.

http://www.skywagons.com/modaddress.html

http://www.wicksaircraft.com/catalog...407/index.html

Get with the Cessna Pilots Assoc and they'll help you out too. There
was always a lot of talk on the web board about these gap seals.




karl gruber wrote:

News,

Where do you get the "just tape" aileron gap seals?

Karl

  #4  
Old November 23rd 06, 06:04 PM posted to rec.aviation.piloting
karl gruber[_1_]
external usenet poster
 
Posts: 396
Default High wings and structural strength

I didn't think you could get them. Hey, I all over the net!

Karl


"Newps" wrote in message
. ..
Not being a Cessna guy anymore I don't recall which companies sold the
tape kits. Here's a few links for gap seals.

http://www.skywagons.com/modaddress.html

http://www.wicksaircraft.com/catalog...407/index.html

Get with the Cessna Pilots Assoc and they'll help you out too. There was
always a lot of talk on the web board about these gap seals.




karl gruber wrote:

News,

Where do you get the "just tape" aileron gap seals?

Karl



  #5  
Old November 23rd 06, 05:15 PM posted to rec.aviation.piloting
Kev
external usenet poster
 
Posts: 368
Default High wings and structural strength


Newps wrote:
Kev wrote:

Hmm. So about $100 per pound lost, which isn't too bad. Especially
compared to speed mods like gap seals etc, which cost what? $1000 per
mph gained? Something like that? It's been a while since I
researched that.


Gap seals are dirt cheap. I can get gap seals for my ailerons that are
really just tape. Around $100 for the kit. Several companies sell gap
seals for the flaps of Cessna's. Maybe $300 for a typical 182.


Gap seals should be dirt cheap, but I can't find any for less that
$450, with 8 hours labor (another $500 at least), for about $1000
installed. Where are you finding a $100 legal kit?

Kev

  #6  
Old November 23rd 06, 05:36 PM posted to rec.aviation.piloting
Ron Wanttaja
external usenet poster
 
Posts: 756
Default High wings and structural strength

On 23 Nov 2006 09:15:40 -0800, "Kev" wrote:

Gap seals are dirt cheap. I can get gap seals for my ailerons that are
really just tape. Around $100 for the kit. Several companies sell gap
seals for the flaps of Cessna's. Maybe $300 for a typical 182.


Gap seals should be dirt cheap, but I can't find any for less that
$450, with 8 hours labor (another $500 at least), for about $1000
installed. Where are you finding a $100 legal kit?


Mine cost $5 for a lifetime supply, at Lowes Aerospace. On Experimentals, at
least, we can just use duct tape. I replace it every three years or so, if it
looks like it's starting to separate.

Doesn't improve the speed (very little WOULD, in this airplane) but it increases
the aileron effectiveness.

Ron Wanttaja
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
terminology questions: turtledeck? cantilever wing? Ric Home Built 2 September 13th 05 09:39 PM
Control Reversal in WWII Eunometic Military Aviation 14 June 27th 04 01:03 PM
Avoiding Vne K.P. Termaat Soaring 120 April 7th 04 07:56 PM
Discus CS grounded in France Marc Till Soaring 47 September 20th 03 10:09 AM


All times are GMT +1. The time now is 01:27 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AviationBanter.
The comments are property of their posters.