![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
On Sunday, October 30, 2016 at 12:24:13 PM UTC-4, wrote:
Steve Bralla used to make and sell tools used to help align the wing spar pin bushings during assembly. He contacted me recently and said he had lost access to the machine shop. He graciously offered me the opportunity to take over the product line, and I am now in production. I will add them to my website shortly (www.mmfabrication.com) If you need one, please contact me through the website. And a big "Thank You" to Steve! Would this work with a Ventus? Do you have any photos? Dennis |
#2
|
|||
|
|||
![]()
Le mardi 1 novembre 2016 16:21:12 UTC+1, HGXC a écritÂ*:
Would this work with a Ventus? Do you have any photos? Dennis Yes, works on my Ventus cM. |
#3
|
|||
|
|||
![]()
On Tuesday, November 1, 2016 at 11:48:41 AM UTC-4, Tango Whisky wrote:
Le mardi 1 novembre 2016 16:21:12 UTC+1, HGXC a écritÂ*: Would this work with a Ventus? Do you have any photos? Dennis Yes, works on my Ventus cM. OK so I slide both wings into the glider but they are resistive to go the final inch. (Typical for me with my Ventus) Then I insert this tool into one of the pins holes .... how does this effect the pin hole of the wing behind the closer wing? Dennis |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS: Eccentric Assembly Tools | SteveB_Z5 | Soaring | 18 | December 16th 13 06:30 PM |
FS: ECCENTRIC ASSEMBLY TOOLs | SteveB_Z5 | Soaring | 17 | March 22nd 13 07:40 PM |
FS: Eccentric Assembly Tools | SteveB_Z5 | Soaring | 0 | July 27th 12 11:52 PM |
FS: Eccentric Assembly Tools | SteveB_Z5 | Soaring | 0 | January 21st 12 05:37 PM |
Wing assembly dollies | Udo | Soaring | 1 | December 2nd 10 02:51 AM |