|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
November 2nd 16, 03:02 PM
posted to rec.aviation.soaring
|
|||
|
|||
Eccentric cam wing assembly tools
On Tuesday, November 1, 2016 at 11:48:41 AM UTC-4, Tango Whisky wrote:
Le mardi 1 novembre 2016 16:21:12 UTC+1, HGXC a écritÂ*: Would this work with a Ventus? Do you have any photos? Dennis Yes, works on my Ventus cM. OK so I slide both wings into the glider but they are resistive to go the final inch. (Typical for me with my Ventus) Then I insert this tool into one of the pins holes .... how does this effect the pin hole of the wing behind the closer wing? Dennis 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FS: Eccentric Assembly Tools | SteveB_Z5 | Soaring | 18 | December 16th 13 06:30 PM |
| FS: ECCENTRIC ASSEMBLY TOOLs | SteveB_Z5 | Soaring | 17 | March 22nd 13 07:40 PM |
| FS: Eccentric Assembly Tools | SteveB_Z5 | Soaring | 0 | July 27th 12 11:52 PM |
| FS: Eccentric Assembly Tools | SteveB_Z5 | Soaring | 0 | January 21st 12 05:37 PM |
| Wing assembly dollies | Udo | Soaring | 1 | December 2nd 10 02:51 AM |
Hybrid Mode
