If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Al-Ko Trailer Tongue failure
On Friday, March 2, 2018 at 10:39:45 AM UTC-8, Papa3 wrote:
Nope. Thought about that. Plenty of room to drop it without needing to jack up the trailer first, even with one tire down. Worst case can unhook the hitch, chock both wheels, and drop the front end. Lots of clearance that way. I once drew up plans for a spare tire post for a Cobra that locates the spare on the side of the trailer, just forward of the right fender. As I recall, it bolted to reinforced areas already in the underside of the trailer bed, with maybe one extra hole required. I wouldn't be averse to fabbing a couple of them. --Bob K. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Komet Trailer tongue surge damper needed | [email protected] | Soaring | 3 | May 21st 15 05:02 AM |
Trailer Tongue Gas Strut replacement | Colin Mead | Soaring | 2 | May 18th 12 03:17 PM |
Komet trailer tongue | key[_2_] | Soaring | 6 | February 5th 11 01:19 AM |
Trailer tongue failure | [email protected] | Soaring | 8 | March 17th 08 03:45 AM |
US source for wheel on the tongue of Cobra trailer? | Mark Zivley | Soaring | 3 | January 18th 05 03:51 AM |